Removal Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the fluid level in the brake master cylinder reservoir.
- If the brake fluid level is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed from the reservoir before proceeding.
- If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the midway point before proceeding.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Unclamp the wheel speed sensor (WSS) harness from the lower control arm.
- Remove both upper and lower caliper bolts (3) from the caliper (1).
- Pull the caliper (2) straight off of the bracket and secure out of the way with heavy mechanics wire (1). DO NOT disconnect the hydraulic brake flexible hose from the caliper.
- Remove the inboard and outboard pads from the brake caliper bracket.
NOTE:
Support the brake caliper with heavy mechanic's wire or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.