LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (Disc Brake System) >> Repair Instructions >> Brake Caliper Bracket Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Brake Dust Caution in Cautions and Notices.
    NOTE: Refer to BRAKE CALIPER SUPPORTING TO PREVENT HOSE DAMA in Cautions and Notices.
  1. Remove the caliper from the mounting bracket and support the caliper with heavy mechanics wire or equivalent. It is not necessary to disconnect the hydraulic brake flexible hose from the caliper.
    2. Fig 1: Locating Brake Caliper Components
    GM177032Courtesy of GENERAL MOTORS CORP.
  2. Remove the brake pads (5) from the brake caliper bracket (3).
  3. Remove the brake pad retainers (4) from the brake caliper bracket.
    4. Fig 2: Ensuring Caliper Bolt Boots Proper Installation
    GM344282Courtesy of GENERAL MOTORS CORP.
  4. Remove the brake caliper bracket bolts (2).
  5. Use a wire brush in order to remove any thread locker and debris from the bolt threads.
  6. Remove the brake caliper bracket (1).
  7. Remove the brake caliper bolt boots (3) from the brake caliper bracket (1).
  8. Inspect and replace the brake caliper bracket if cracks or deformation damage exists.
  9. Use a wire brush in order to remove any rust and debris from the brake caliper bracket where the brake pad retainers contact the brake caliper bracket.
  10. Use a wire brush in order to clean away any rust and debris from the brake pads where the brake pads contact the brake pad retainers.
scientia non olet · About LEMON Manuals