Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear seat to the vehicle.
- Secure the front seat riser latches into the floor.
Ensure that the latch is secured on both pins.
- Enable the SIR, if equipped. Refer to SIR Disabling and Enabling Zone 10 and SIR Disabling and Enabling Zone 12 .
- Tilt the rear seat assembly down and latch the rear seat riser latches into the floor.
- Tilt the rear seat back upright.
- Return the rear seat to its original position.