Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Trim Covers - Sit-N-Lift

Courtesy of GENERAL MOTORS CORP.

Remove the trim covers from the upper seat base.

Fig 2: View Of Front Lower Base - Sit-N-Lift

Courtesy of GENERAL MOTORS CORP.

Remove the trim cover from the front lower base.

Fig 3: Locating Lock Bolts That Secure Seat Base Rear Hooks To Floor - Sit-N-Lift

Courtesy of GENERAL MOTORS CORP.

Remove the lock bolts that secure the seat base rear hooks to the floor.

Fig 4: Locating Lower Anchor Bolt For Seat Belt - Sit-N-Lift

Courtesy of GENERAL MOTORS CORP.

Remove the lower anchor bolt from the seat belt.

Fig 5: Locating Electrical Connector - Sit-N-Lift

Courtesy of GENERAL MOTORS CORP.

Pull back on the quarter trim panel to access the electrical connection for the power seat.
Disconnect the electrical connector.

Fig 6: Disengaging Locking Hooks - Sit-N-Lift

Courtesy of GENERAL MOTORS CORP.

Use a flat-bladed tool to disengage the locking hooks from the floor anchor.
Tilt the seat base forward about 45 degrees to disengage the front hooks.
Remove the seat from the vehicle.