Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the cap or tape from the evaporator lines.
- Install the new sealing washers onto the evaporator lines. Refer to Sealing Washer Replacement .
- Install the auxiliary TXV to the evaporator core.
- Install the auxiliary TXV to the evaporator core mounting bolts.
Tighten: Tighten the bolts to 3.5 N.m (31 lb in).
- Remove the cap or tape from the A/C lines.
- Install the new sealing washers onto the A/C line. Refer to Sealing Washer Replacement .
- Install the A/C lines to the auxiliary TXV.
- Install the auxiliary TXV line block fitting retaining bolt.
Tighten: Tighten the nut to 11 N.m (97 lb in).
- Install the auxiliary TXV line clamp to the HVAC module assembly.
- Install the auxiliary TXV line clamp screw.
Tighten: Tighten the screw to 1.6 N.m (14 lb in).
- Install a new foam wrap to the auxiliary TXV.
- Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
- Leak test the fittings of the component using J 39400-A .
- Install the left lower quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter - Left in Interior Trim.
NOTE:
Refer to Fastener Notice
.