LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Suction Hose Replacement (w/C60 Compressor) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Cap or tape the open air conditioning (A/C) components immediately in order to prevent system contamination.
    Fig 1: Identifying Suction & Discharge Hoses (w/C60 Compressor)
    GM1547616Courtesy of GENERAL MOTORS CORP.
  1. Recover the refrigerant from the A/C system. Refer to Refrigerant Recovery and Recharging .
  2. Remove the suction hose to A/C evaporator tube bolt (1).
  3. Remove the suction hose from the A/C evaporator tube.
  4. Remove and discard the sealing washer (2).
  5. Cap or tape off the A/C evaporator tube.
  6. Disconnect the A/C compressor electrical connector.
    7. Fig 2: Identifying Compressor Hoses & Mounting Equipment
    GM1547615Courtesy of GENERAL MOTORS CORP.
  7. Remove the suction hose to A/C compressor nut.
  8. Remove the suction hose (5) from the A/C compressor.
  9. Remove and discard the sealing washer (2).
  10. Cap or tape the suction port on the A/C compressor.
  11. Remove the suction hose.
scientia non olet · About LEMON Manuals