LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Receiver Dehydrator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Receiver Dehydrator
    GM1547626Courtesy of GENERAL MOTORS CORP.
  1. If replacing the receiver dehydrator, add the specified amount of PAG oil directly to the receiver dehydrator. Refer to Refrigerant System Capacities .
  2. Remove the cap or tape from the condenser lower openings.
  3. Install NEW lower receiver dehydrator sealing washers.
  4. Install the receiver dehydrator.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the receiver dehydrator lower bolts (3).

    Tighten:  Tighten the bolts to 16 N.m (12 lb ft).

  6. Install the receiver dehydrator upper bracket screw (4).

    Tighten:  Tighten the bolt to 16 N.m (12 lb ft).

  7. Remove the caps or tape from the open A/C lines.
  8. Install the A/C condenser. Refer to Condenser Replacement .
scientia non olet · About LEMON Manuals