Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Install the secondary mode door (7).
- Install the mode actuator levers (4, 6). The pin on lever (4) should be seen through the opening in lever (6).
- Install the mode actuator cam (1). The pin on lever (6) should be seen through this opening (5) in the cam.
- Install the mode actuator lever cover (4).
- Install the mode actuator lever cover bolts/screws (3).
Tighten: The bolts/screws to 1.2 N.m (11 lb in).
- Install the mode actuator (2).
- Install the mode actuator bolts/screws (1).
Tighten: The bolts/screws to 1.2 N.m (11 lb in).
- Install the heater core cover. Refer to Heater Core Cover Replacement .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.