Removal Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the heater inlet and outlet hoses from the auxiliary heater inlet/outlet pipes using J 38185 or (SA9111E).
- Drain the coolant system. Refer to Draining and Filling Cooling System (Static Fill) or Draining and Filling Cooling System (Vac-N-Fill) .
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the auxiliary heater inlet/outlet pipe clip nut (1).
- Remove the auxiliary heater inlet/outlet pipe clip nut (1).
- Remove the auxiliary heater inlet/outlet pipe clip (1).
- Remove the auxiliary heater inlet/outlet pipe (2) clip nut (1).
- Remove the auxiliary heater inlet/outlet pipe clip (1).
- Remove the auxiliary inlet/outlet pipe (2) clip nut (1).
- Using the J 38185 or (SA9111E), disconnect the auxiliary heater inlet/outlet hoses (2) at the rear of the vehicle.
- Remove the auxiliary heater inlet/outlet hose assembly.