Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Install the defrost actuator door (5).
- Install the defrost actuator (3).
- Install the defrost actuator bolts/screws (4).
Tighten: Tighten the bolts/screws to 1.2 N.m (11 lb in).
- Install the defroster cover (2).
- Install the defroster cover bolts/screws (1).
Tighten: Tighten the bolts/screws to 1.2 N.m (11 lb in).
- Install the I/P carrier. Refer to Instrument Panel (I/P) Carrier Replacement in Instrument Panel, Gages and Console.
- Re-calibrate the actuators. Refer to Re-Calibrating Actuators .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.