Removal Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Recover the refrigerant from the air conditioning (A/C) system. Refer to Refrigerant Recovery and Recharging .
- Disconnect the A/C compressor electrical connector.
- If equipped with a C60 compressor, remove the discharge line (3) to compressor nut (4).
- Remove the suction line (5) to compressor nut (4).
- Remove the discharge (3) and suction (5) lines from the compressor.
- Remove and discard the sealing washers (2).
- If equipped with a C69 compressor, remove the discharge line (5) to compressor nut (4).
- Remove the suction line (2) to compressor nut (1).
- Remove the discharge (5) and suction (5) lines from the compressor.
- Remove and discard the sealing washers (3).
- Release the drive belt tensioner.
- Remove the drive belt from the generator pulley.
- Remove the drive belt from the A/C compressor.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the air deflector bolts and deflector.
- Remove the passenger side engine splash shield. Refer to Splash Shield Replacement - Engine .
- Remove the A/C compressor bolts.
- Remove the A/C compressor.
IMPORTANT:
Cap or tape the openings of the A/C lines immediately in order to prevent system contamination.
IMPORTANT:
Cap or tape the openings of the A/C lines immediately in order to prevent system contamination.