LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement - Auxiliary (Without E59) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the accessory panel. Refer to Accessory Panel Replacement - Rear in Interior Trim.
  2. Fig 1: View Of Cover For Rear Trim Panel
    GM734336Courtesy of GENERAL MOTORS CORP.
  3. Remove the screws from the hinged cover.
  4. Remove the cover from the rear trim panel.
  5. Release the tabs and pull out the trim panel.
  6. Disconnect the auxiliary blower motor electrical connector.
  7. Disconnect the auxiliary blower motor resistor electrical connector.
  8. Disconnect the auxiliary air temperature actuator electrical connector.
  9. Fig 2: View Of Auxiliary Blower Motor
    GM691600Courtesy of GENERAL MOTORS CORP.
  10. Remove the auxiliary blower motor mounting screws.
  11. Remove the auxiliary blower motor from the blower motor housing.