LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement - Auxiliary (Without E59) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Auxiliary Blower Motor
    GM691600Courtesy of GENERAL MOTORS CORP.
  1. Install the auxiliary blower motor to the blower motor housing.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the auxiliary blower motor mounting screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  3. Connect the auxiliary air temperature actuator electrical connector.
  4. Connect the auxiliary blower motor resistor electrical connector.
  5. Connect the auxiliary blower motor electrical connector.
    6. Fig 2: View Of Cover For Rear Trim Panel
    GM734336Courtesy of GENERAL MOTORS CORP.
  6. Install the trim panel and press firmly into the tabs.
  7. Align the cover and fasten the screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  8. Install the accessory panel. Refer to Accessory Panel Replacement - Rear in Interior Trim.
scientia non olet · About LEMON Manuals