LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (HVAC Systems - Manual) >> Repair Instructions >> Recirculation Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Recirculation Door & Components
    GM1548539Courtesy of GENERAL MOTORS CORP.
  1. Install the recirculation actuator levers (3, 6), if necessary.
  2. Install the recirculation actuator (7).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the recirculation actuator bolts/screws (1).

    Tighten:  Tighten the screws to 1.2 N.m (11 lb in).

    4. Fig 2: Locating Recirculation Actuator
    GM1548559Courtesy of GENERAL MOTORS CORP.
  4. Connect the recirculation actuator electrical connector (1).
  5. Install the upper I/P trim pad. Refer to Upper Trim Pad, Outer Trim Cover, Fuse Block Access Cover Replacement - Instrument Panel in Instrument Panel, Gages and Console.
  6. Re-calibrate the actuators. Refer to Re-Calibrating Actuators .
scientia non olet · About LEMON Manuals