Test Description

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

2: This step checks for continuous operation of the blower motor.
3: This step tests for a short to voltage in the blower motor control circuits.

Blower Motor Always On

Step	Action	Yes	No
Schematic Reference: HVAC Schematics Connector End View Reference: HVAC Connector End Views DEFINITION: The blower motor is ON while the blower motor switch is in the OFF position.
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Turn ON the ignition, with the engine OFF. Place the blower motor switch in the OFF position. Is the blower motor OFF?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	IMPORTANT: The blower motor switch must remain in the OFF position during this step. Turn OFF the ignition. Disconnect the blower motor resistor assembly connector. Turn ON the ignition, with the engine OFF. Probe each blower motor control circuit with a test lamp that is connected to a good ground. Does the test lamp illuminate while connected to any of the blower motor control circuits?	Go to Step 4	Go to Step 5
4	Test the appropriate blower motor control circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 9	Go to Step 6
5	Inspect for poor connections at the harness connectors of the blower motor resistor assembly. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 9	Go to Step 7
6	Inspect for poor connections at the harness connector of the HVAC control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 9	Go to Step 8
7	Replace the blower motor resistor assembly. Refer to Blower Motor Resistor Assembly Replacement . Did you complete the replacement?	Go to Step 9	-
8	Replace the HVAC control module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup and programming. Did you complete the replacement?	Go to Step 9	-
9	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2