Conditions for Setting the DTC

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

The EBCM will set the DTC when one or more of the following conditions have occurred:

The yaw rate signal is less than 0.18 volt or greater than 4.84 volts.
The yaw rate signal changes to rapidly based on vehicle dynamics.
The internal calibration in the yaw rate is out of range.
The yaw and lateral acceleration sensor has failed and internal self check test.