Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Use clean brake fluid to lubricate the new grommets (4 and 7) and the grooves in the reservoir.
- Insert the grommets into the grooves in the reservoir. Verify that the grommets are properly seated.
- Connect the reservoir (3) to the master cylinder body (5). Use your hand in order to press the reservoir straight down into the cylinder body.
- Drive in the master cylinder reservoir pins (6) in order to retain the reservoir.
- Install the master cylinder. Refer to Master Cylinder Replacement .