LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 215 (Hydraulic Brake System) >> Repair Instructions >> Master Cylinder Fluid Level Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Master Cylinder Fluid Level Sensor Electrical Connector
    GM385563Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector (2) from the fluid level sensor (1).
    2. Fig 2: Removing Brake Fluid Level Sensor
    GM176836Courtesy of GENERAL MOTORS CORP.
  2. Remove the fluid level sensor (1). Use needle nose pliers in order to compress the switch locking tabs at the outboard side of the master cylinder.
scientia non olet · About LEMON Manuals