LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Drive Axle - Limited-Slip Differential) >> Diagnostic Information and Procedures >> Differential Lock Indicator Inoperative >> Test Description

Test Description

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  This step tests for an intermittent condition.
  2. 3:  This step determines if the failure is the result of a faulty instrument cluster.
Differential Lock Indicator Inoperative

Step Action Yes No
Schematic Reference:  All-Wheel Drive Schematics  
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
Verify the fault is present.
Does the system operate normally?
Go to Testing for Intermittent Conditions and Poor Connections Go to Step 3 
  1. Turn ON the ignition, with the engine OFF.
  2. Install a scan tool.
  3. Use the scan tool to command the AWD system disabled.
Does the AWD Disable indicator turn ON?
Go to Step 4  Go to Step 5 
4 Replace the PCM for 3.5L or the TCM for 3.9L. Refer to Control Module References for replacement, setup and programming.
Did you complete the replacement?
Go to Step 6  -
5 Replace the instrument panel cluster. Refer to Cluster, Cluster Trim Plate Replacement - Instrument Panel .
Did you complete the replacement?
Go to Step 6  -
6 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3