LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Suspension Control System - Suspension Leveling) >> Repair Instructions >> Inflator Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Inflator Solenoid
    GM381393Courtesy of GENERAL MOTORS CORP.
  1. Install the inflator solenoid washer over the fill valve.
  2. Install the inflator solenoid.
    3. NOTE: Refer to Fastener Notice .
  3. Install the inflator solenoid nut.

    Tighten:  Tighten the inflator solenoid nut to 3 N.m (27 lb in).

  4. Install the inflator solenoid fill valve nut.

    Tighten:  Tighten the inflator solenoid fill valve nut to 3 N.m (27 lb in).

  5. Install the inflator solenoid fill valve cap.
    6. Fig 2: Locating Inflator Solenoid Electrical Connector
    GM880782Courtesy of GENERAL MOTORS CORP.
  6. Install the air lines to the inflator solenoid.
  7. Connect the inflator solenoid electrical connector.
  8. Install the left rear quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter - Left .
  9. Install the ELC/TRAILER fuse.
scientia non olet · About LEMON Manuals