LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Suspension Control System - Suspension Leveling) >> Diagnostic Information and Procedures >> DTC 011 >> Test Description

Test Description

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  This step tests for voltage at the coil side of the accessory inflator valve. The ELC relay fuse supplies power to the coil side of the accessory inflator valve.
  2. 3:  This step verifies that the height sensor is providing ground to the accessory inflator valve.
  3. 4:  This step tests if ground is constantly being applied to the accessory inflator valve.
  4. 9:  This step verifies that the automatic level control sensor is self tested after replacement.
DTC 011

Step Action Yes No
Schematic Reference: Automatic Level Control Suspension Schematics 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
  1. Turn ON the ignition.
  2. Disconnect the accessory inflator valve.
  3. Probe the battery positive voltage circuit of the accessory inflator valve with a test lamp that is connected to a good ground.
Does the test lamp illuminate?		 Go to Step 3  Go to Step 7 
3 
  1. Connect a test lamp between the control circuit of the accessory inflator valve and the battery positive voltage circuit of the accessory inflator valve.
  2. With the accessory inflator switch, command the accessory inflator valve ON and OFF.
Does the test lamp turn ON and OFF with each command?		 Go to Step 5  Go to Step 4 
4  Test the control circuit of the accessory inflator valve for the following conditions:
  • A ground
  • An open


Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 10  Go to Step 6 
5 Inspect for poor connections at the accessory inflator valve. Refer to Testing for Intermittent Conditions and Poor Connections andWiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 10  Go to Step 8 
6 Inspect for poor connections at the harness connector of the height sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 10  Go to Step 9 
7 Repair the battery positive voltage circuit of the accessory inflator valve. Refer to Wiring Repairs in Wiring Systems.
Did you complete the repair?		 Go to Step 10  -
8 Replace the accessory inflator valve. Refer to Inflator Solenoid Replacement .
Did you complete the replacement?		 Go to Step 10  -
9 
IMPORTANT: System untested code will continue to flash until Self test has been completed after automatic level control sensor replacement.
Replace the automatic level control sensor. Refer to Automatic Level Control Sensor Replacement .Did you complete the replacement?		 Go to Step 10  -
10 Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals