LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the brake caliper and bracket. Hang the caliper and the bracket from the vehicle. DO NOT allow the caliper and the bracket to hang by the brake hose. Refer to Brake Caliper Replacement - Front in Disc Brakes.
  4. Remove the brake rotor. Refer to Brake Rotor Replacement - Front in Disc Brakes.
    5. Fig 1: Extracting Stud From Hub
    GM144028Courtesy of GENERAL MOTORS CORP.
  5. Use the J 6627-A  in order to extract the stud (1) from the hub (2). See Special Tools .
scientia non olet · About LEMON Manuals