LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear (Without Independent Rear Suspension) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Five lug pattern hub shown will work on vehicles with six lug pattern.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the brake caliper. Refer to Brake Caliper Replacement - Rear in Disc Brakes.
    4. Fig 1: Removing/Installing Wheel Bearing/Hub Bolts
    GM1596606Courtesy of GENERAL MOTORS CORP.
  4. Remove and DISCARD the wheel bearing/hub bolts.
  5. Remove the wheel bearing/hub.
  6. Disconnect the wheel speed sensor electrical connector.
scientia non olet · About LEMON Manuals