LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear (Without Independent Rear Suspension) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Wheel Bearing/Hub Bolts
    GM1596606Courtesy of GENERAL MOTORS CORP.
  1. Connect the wheel speed sensor electrical connector.
  2. Install the wheel bearing/hub.
    3. CAUTION: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.
    NOTE: Refer to Fastener Notice .
  3. Install the NEW wheel bearing/hub bolts.

    Tighten:  Tighten the NEW wheel bearing/hub bolts to 80 N.m (59 lb ft).

  4. Install the brake caliper. Refer to Brake Caliper Replacement - Rear in Disc Brakes.
  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals