LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear (Independent Rear Suspension) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the knuckle. Refer to Knuckle Replacement .
    4. Fig 1: Locating Wheel Bearing/Hub Assembly Knuckle Bolts
    GM809968Courtesy of GENERAL MOTORS CORP.
  4. Remove the wheel bearing/hub assembly knuckle bolts (1).
    5. Fig 2: View Of Wheel Bearing/Hub Assembly And The Knuckle
    GM809973Courtesy of GENERAL MOTORS CORP.
  5. Remove the wheel bearing/hub assembly (1) from the knuckle (2).
scientia non olet · About LEMON Manuals