LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear (Independent Rear Suspension) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Bearing/Hub Assembly And The Knuckle
    GM809973Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel bearing/hub assembly (1) on to the knuckle (2).
    2. NOTE: Refer to Fastener Notice .
    Fig 2: Locating Wheel Bearing/Hub Assembly Knuckle Bolts
    GM809968Courtesy of GENERAL MOTORS CORP.
  2. Install the bolts (1) into the wheel bearing/hub assembly.

    Tighten:  Tighten the wheel bearing/hub bolts to 130 N.m (96 lb ft).

  3. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals