LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Rear Suspension System) >> Repair Instructions >> Tie Rod Replacement (Front Wheel Drive) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. If the vehicle is equipped with automatic level control, perform the following steps:
    1. Disconnect the automatic level control sensor electrical connector.
      2. IMPORTANT: Do NOT disconnect the automatic level control sensor link from the sensor arm.
    2. Disconnect the height sensor link from the rear axle tie rod.
    3. Fig 1: Identifying Rear Axle Tie Rod Bolts (Front Wheel Drive)
    GM379674Courtesy of GENERAL MOTORS CORP.
  3. Remove the rear axle tie rod bolts.
  4. Remove the rear axle tie rod from the vehicle.
scientia non olet · About LEMON Manuals