LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Rear Suspension System) >> Repair Instructions >> Tie Rod Replacement (Front Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Rear Axle Tie Rod Bolts (Front Wheel Drive)
    GM379674Courtesy of GENERAL MOTORS CORP.
  1. Install the rear axle tie rod to the vehicle.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the rear axle tie rod bolts and nuts.

    Tighten:  Tighten the rear axle tie rod bolts to 125 N.m (92 lb ft).

  3. If the vehicle is equipped with automatic level control, perform the following steps:
      NOTE: When you are servicing the automatic level control sensor link, ensure that the sensor link and the sensor arm are not damaged. Ensure the sensor arm and the sensor link are properly oriented. Improper orientation of the sensor arm and the sensor link may cause damage to the automatic level control system or the vehicle.
    1. Install the height sensor link to the rear axle tie rod.
    2. Connect the automatic level control sensor electrical connector.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals