LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Rear Suspension System) >> Repair Instructions >> Tie Rod Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Tie Rod Nut (All Wheel Drive)
    GM629245Courtesy of GENERAL MOTORS CORP.
  1. Install the tie rod.
    2. NOTE: Refer to Fastener Notice .
  2. Install the tie rod nut.

    Tighten:  Tighten the tie rod nut to 80 N.m (59 lb ft).

  3. Install the tie rod bolt.

    Tighten:  Tighten the tie rod bolt to 85 N.m (63 lb ft).

  4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Adjust the rear toe angle. Refer to Rear Toe Adjustment in Wheel Alignment.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals