LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft.
  2. Install the spare tire to the spare tire hoist.
  3. Install the left and right stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement .
    4. Fig 1: View Of Left And Right Side Stabilizer Shaft Insulators And Brackets (All Wheel Drive)
    GM629208Courtesy of GENERAL MOTORS CORP.
  4. Install the left and right stabilizer shaft insulators and brackets.
  5. Install the clamp holding the right park brake cable to the stabilizer shaft.
  6. Install the load level sensor.
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals