LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Locating Stabilizer Shaft Link Nuts (All Wheel Drive)
    GM629209Courtesy of GENERAL MOTORS CORP.
  2. Use a wrench in order to hold the stabilizer shaft link. Remove the stabilizer shaft link nuts.
  3. Remove the stabilizer shaft link.
scientia non olet · About LEMON Manuals