LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Stabilizer Shaft Link Nuts (All Wheel Drive)
    GM629209Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft link.
  2. NOTE: Refer to Fastener Notice.
  3. Install the stabilizer shaft link nuts.

    Tighten:  Tighten the stabilizer shaft link nuts to 40 N.m (30 lb ft).

  4. Lower the vehicle.