LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left And Right Side Stabilizer Shaft Insulators And Brackets (All Wheel Drive)
    GM629208Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft insulators to the stabilizer shaft.
  2. Install the stabilizer shaft insulator brackets.
    3. NOTE: Refer to Fastener Notice .
  3. Install the stabilizer shaft insulator bracket bolts and nuts.

    Tighten:  Tighten the stabilizer shaft insulator bracket nuts to 85 N.m (63 lb in).

  4. Install the load level sensor for the left side.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals