LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Rear Suspension System) >> Repair Instructions >> Rear Axle Lower Control Arm Bushing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lower control arm.
    2. Fig 1: View Of Bushing To Crossmember
    GM771999Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Identify the orientation of the voids in the bushing to the crossmember.
  2. Remove the bushing from the crossmember.
    3. Fig 2: Removing The Bushing From The Crossmember Using J 21474-01
    GM773977Courtesy of GENERAL MOTORS CORP.
  3. In order to remove the bushing from the crossmember, use the following tools from the J 21474-01  :
    • J-6627-4 (1)
    • J-45411 (2)
    • J-21474-8 (3)
    • J-21474-4 (4)
scientia non olet · About LEMON Manuals