LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Rear Drive Axle) >> Repair Instructions >> Torque Tube Mounting Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Place a jack stand under the torque tube.
  3. Remove the mounting bracket-to-body bolts (5) from the torque tube bracket (4).
  4. Lower the jack stand slightly in order to gain access to the torque tube bracket.
    5. Fig 1: Torque Tube And Components
    GM630649Courtesy of GENERAL MOTORS CORP.
  5. Remove the torque tube-to-bracket through bolt (7), nut (1), washers (2, 8) and spacers (3, 6).
  6. Remove the torque tube bracket.
scientia non olet · About LEMON Manuals