Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Drive Pinion Housing O-Ring Seal

Courtesy of GENERAL MOTORS CORP.

Lubricate the O-ring seal with synthetic gear oil GM P/N United States 12378514 Canada P/N 88901045 or equivalent.
Using the J 44915 , install the oil seal (2) to the drive pinion housing. See Special Tools .
Install the O-ring seal (4) to the drive pinion housing.

Fig 2: View Of Drive Pinion And Housing Assembly

Courtesy of GENERAL MOTORS CORP.

Carefully install the drive pinion housing assembly (1) and shim (2) to the differential carrier (3).

Fig 3: Identifying Pinion Housing-To-Differential Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the pinion housing-to-differential mounting bolts (1).
Tighten: Tighten the bolts to 10 N.m (106 lb in).

Fig 4: View Of Drive Pinion Housing Oil Seal

Courtesy of GENERAL MOTORS CORP.

Lubricate the sealing surfaces of the drive pinion oil seal (1) with synthetic gear oil GM P/N United States 12378514 Canada P/N 88901045 or equivalent.
Install the torque tube assembly. Refer to Torque Tube Assembly Replacement .
Fill the differential with synthetic gear oil. Refer to Lubricant Change .