Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Differential Carrier Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

Install the differential-to-cradle bushings (4).
Lower and remove the jack stand.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the cradle-to-differential mounting bolts (5), bushings (3), washers (2) and nuts (1) to the differential.
Tighten: Tighten the bolts and nuts to 50 N.m (37 lb ft).

Fig 2: Torque Tube And Components

Courtesy of GENERAL MOTORS CORP.

Secure the torque tube-to-bracket through bolt (7) and nut (1).
Tighten: Tighten the bolt and nut to 64 N.m (47 lb ft).
Lower the vehicle.