Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Lower Control Arm To Crossmember Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Tighten the lower control arm mounting nuts (3, 4).
Tighten:
- Tighten the nut (3) to 125 N.m (107 lb ft).
- Tighten the nut (4) to 50 N.m (37 lb ft).
Test drive the vehicle.