LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Wiring Harness Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the case side cover. Refer to Case Side Cover Replacement .
    2. Fig 1: Locating Wiring Harness & Electrical Connectors
    GM48209Courtesy of GENERAL MOTORS CORP.
  2. Use a small flat-bladed tool in order to remove the wiring harness from the solenoid valve(s) (315A, 315B, 322, 334 and/or 440), TFP manual valve position switch (395) and/or the temperature sensor (391).
    3. Fig 2: View Of Transmission Internal Wiring Harness
    GM48210Courtesy of GENERAL MOTORS CORP.
  3. Remove the wiring harness (224).
  4. Remove the clips retaining the solenoid(s).
scientia non olet · About LEMON Manuals