LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Transmission Vent Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement in Engine Controls - 3.5L (LX9).
  2. Use a hammer and a chisel in order to raise the transaxle vent seat off of the transaxle.
  3. Fig 1: View Of Transaxle Vent
    GM164785Courtesy of GENERAL MOTORS CORP.
  4. Use a flat-bladed tool in order to pry the transaxle vent (37) out of the transaxle.