LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Thermo Element Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Thermo Element Plate
    GM164816Courtesy of GENERAL MOTORS CORP.
  1. Use the J 34094-A  to set the middle thermo pin (123). See Special Tools .
  2. Install the new thermo element plate (122).
  3. Install the pin and washer (120).
  4. Use the J 34094-A  to set the height of the pin and washer (120) furthest from the accumulator. See Special Tools .
  5. Use the J 34094-A  to set the height of the second pin and washer (120). See Special Tools .
    6. Fig 2: View Of Thermo Element & Plate
    GM164817Courtesy of GENERAL MOTORS CORP.
  6. Carefully install the thermo element (121) between the two pin and washers (120). The V in the thermo element (121) must contact the thermo element plate (122).
  7. Install the oil pan. Refer to Oil Pan Replacement .
  8. Refill fluid as necessary. Refer to Capacities - Approximate Fluid .
scientia non olet · About LEMON Manuals