LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Output Shaft Replacement (M15) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Output Shaft Components
    GM223317Courtesy of GENERAL MOTORS CORP.
  1. Install the drive axle retaining ring (509) and the output shaft differential inboard snap ring (512) onto the output shaft (510).
  2. Install the fourth clutch bearing (511) onto the output shaft (510).
  3. Hold the front differential carrier in place and carefully install the output shaft (510) into the transmission through the left wheel opening. Extend the output shaft through the differential side gear.
  4. Install the case extension housing. Refer to Case Extension Housing Replacement .
  5. Connect the left drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement - Front in Wheel Drive Shafts.
scientia non olet · About LEMON Manuals