LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Oil Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Pump & Valve Body View
    GM48212Courtesy of GENERAL MOTORS CORP.
  1. Install the oil pump (200) to valve body (300).
    2. Fig 2: Identifying Oil Pump Bolt Lengths And Positions
    GM164795Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the oil pump bolts (205-207).

    Tighten: 

    • Tighten the M6 X 1.0 X 20 bolt to 8 N.m (70 lb in).
    • Tighten the M6 X 1.0 X 85 bolt to 12 N.m (106 lb in).
    • Tighten the M6 X 1.0 X 95 bolt to 16 N.m (11 lb ft).

  3. Install the case side cover. Refer to Case Side Cover Replacement 
scientia non olet · About LEMON Manuals