Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Flywheel To Torque Converter Bolts

Courtesy of GENERAL MOTORS CORP.

Install the flywheel to torque converter bolts.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Use the J 37623 to hold the flywheel. See Special Tools .
Tighten: Tighten the bolts to 63 N.m (47 lb ft).

Fig 2: Identifying Torque Converter Cover Bolts

Courtesy of GENERAL MOTORS CORP.

Install the torque converter cover. Refer to Torque Converter Cover Replacement .
Lower the vehicle.