LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Filler Tube and Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Do NOT place the fluid filler tube seal on the fluid filler tube when installing the tube or damage to the seal will result.
    Fig 1: Identifying Fluid Filler Tube Seal
    GM368794Courtesy of GENERAL MOTORS CORP.
  1. Install the fluid filler tube seal in the transaxle.
  2. Position the fluid filler tube into the transaxle.
    3. Fig 2: Locating Fluid Filler Tube
    GM368795Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the fluid filler tube bracket bolt through the fluid filler tube bracket.

    Tighten:  Tighten the bolt to 13 N.m (115 lb in).

  4. Lower the vehicle.
  5. At the top of the filler tube Install the retaining nut to the filler tube the EGR at the top of the filler tube.
  6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.5L (LX9).
  7. Inspect for proper fluid level.
  8. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals