LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Case Extension Housing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. If removed, install the drive axle seal.
    2. Fig 1: View Of Case Extension Assembly & Bolts
    GM10517Courtesy of GENERAL MOTORS CORP.
  2. Install the case extension housing (6) with the axle seal and with the O-ring (8).
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the case extension housing bolts (5).

    Tighten:  Tighten the bolts (5) to 36 N.m (27 lb ft).

  4. Install the vehicle speed sensor. Refer to Input Speed Sensor Replacement .
  5. Install the transaxle brace. Refer to Automatic Transmission Brace Replacement (Front Wheel Drive) , Automatic Transmission Brace Replacement (All Wheel Drive)  or Automatic Transmission Brace Replacement (Front Wheel Drive and All Wheel Drive) .
  6. Connect the right drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement - Front in Wheel Drive Shafts.
  7. Lower the vehicle.
    8. NOTE: Do NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints and possible damage to the transaxle.
  8. Adjust the fluid level. Refer to the following information.
  9. Inspect for completion of the repairs.
  10. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals