LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Automatic Transmission Range Selector Cable Lever Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the throttle body air inlet duct. Refer to Air Cleaner Intake Duct Replacement in Engine Controls - 3.5L (LX9).
  2. Remove the automatic transaxle range selector lever cable from the cable lever.
    3. Fig 1: View Of Automatic Transmission Range Selector Cable Lever
    GM161083Courtesy of GENERAL MOTORS CORP.
  3. Remove the automatic transaxle range selector lever nut.
  4. Remove the automatic transaxle range selector lever.
scientia non olet · About LEMON Manuals