LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Automatic Transmission Range Selector Cable Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Automatic Transmission Range Selector Cable Lever
    GM161083Courtesy of GENERAL MOTORS CORP.
  1. Install the automatic transaxle range selector lever.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the automatic transaxle range selector lever nut.

    Tighten:  Tighten the automatic transaxle range selector lever nut to 32 N.m (23 lb ft).

  3. Install the automatic transaxle range selector lever cable to the automatic transaxle range selector lever.
  4. Install the throttle body air inlet duct. Refer to Air Cleaner Intake Duct Replacement in Engine Controls - 3.5L (LX9).
scientia non olet · About LEMON Manuals