LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Automatic Transmission Brace Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Transmission Brace (All Wheel Drive)
    GM1544759Courtesy of GENERAL MOTORS CORP.
  1. Position the transaxle brace (1) to transaxle and engine.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the brace bolts (2, 3).

    Tighten:  Tighten the bolts to 43 N.m (32 lb ft).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals