LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> Accumulator and 2-1 Manual Servo Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Manual 2-1 Band Servo
    GM164811Courtesy of GENERAL MOTORS CORP.
  1. Install the manual 2-1 band servo cover gasket (105) into the case. Lubricate the manual 2-1 band servo cover gasket with automatic transmission fluid.
  2. Install the manual 2-1 band servo (106-116).
  3. Install the manual 2-1 band servo cover (104).
    4. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the manual 2-1 band servo cover bolts (103).

    Tighten:  Tighten the bolts (103) to 25 N.m (18 lb ft).

    5. Fig 2: Identifying Accumulator
    GM164810Courtesy of GENERAL MOTORS CORP.
  5. Install the accumulator (132).
  6. Install the lube oil pipe (130) into the case at the lube hole for the front differential carrier internal gear.
  7. Use a flat-bladed tool in order to lock the lube oil pipe retainer (129) into the case.
    8. Fig 3: Identifying Accumulator & Manual 2-1 Band Servo Cover Bolts
    GM164809Courtesy of GENERAL MOTORS CORP.
  8. Install the accumulator bolts (131).

    Tighten:  Tighten the bolts (131) to 12 N.m (106 lb in).

  9. If removed, install a new filter seal.
  10. Install the filter. Refer to Oil Filter and Seal Replacement .
  11. Install the oil pan. Refer to Oil Pan Replacement .
  12. Lower the vehicle.
scientia non olet · About LEMON Manuals